در هم ریزی منحنی

Merging style-line curves

gp1

Controlling the merging of style-lines

The merging of the curves is controlled by variables that are stored in the powershape.confile. By changing the values assigned to the following variables, you can control the way the curves are merged:

detect_curve_dist: 2.5

This variable defines the distance on either side of a sketched curve, that is to be used to automatically detect the curve for merging. This is equivalent to hit radius.

min_overlap_length: 15.0

This variable defines the minimum overlapping length that is needed to ensure that curve will be considered for merging.

min_overlap_angle: 20.0

This variable defines the minimum angle formed in overlapping area that is needed to ensure that the curve will be considered for merging.

max_apart_in_merging_zone: 10.0

This variable defines the maximum distance between two curves in the middle portion of the overlapping zone.

finishing_stroke_power: 0.5

This variable defines the length of the finishing strokes that are used to refine the rough sketch. The variable will be in the range of 0 >1

 

You may also like...

0 thoughts on “در هم ریزی منحنی”

پاسخ دهید

نشانی ایمیل شما منتشر نخواهد شد. بخش‌های موردنیاز علامت‌گذاری شده‌اند *