ویرایش قالب

Last Editing

Use the Last Editing dialog to assign values and select options associated with the different parameters of a last.

kp10

  1. Enter the values for the following parameters. Alternatively, use the up and down arrows to set the value.
    • Stick length to specify the length of the last, measured using projection on the ground.
    • Toe Spring to specify the height of the point from the ground.
    • Insole length to specify the length of the last measured along the bottom surface.
    • Heel height to specify the height of the heel bottom point from the ground.
    • Girth to specify the perimeter of the cross-section taken at the girth plane.
  2. Use the following buttons to display the options associated with the different last parameters:

The graphic in the dialog changes to reflect the parameter you have selected.

  1. Select Undo the previous operation in the last editing form. Click Redoto cancel the last Undo.
  2. Use Restore to reset values to the original settings for the Last Editing dialog for the model.
  3. Click OK to accept the changes and close the dialog.

 

You may also like...

0 thoughts on “ویرایش قالب”

پاسخ دهید

نشانی ایمیل شما منتشر نخواهد شد. بخش‌های موردنیاز علامت‌گذاری شده‌اند *